Extremity THERMATIC Buff SWITCH Kit up (Break #0444)
Our real have designed Digital Thermatic Buff Switch Kit can make up used with our Thermatic Fans, EWP's and competitors Fans.
The sensing element, a Temperature Probe (Air or Coolant Fitment) senses air temperature as it passes through with the radiator with the sensor placed in the radiator louvre part or the sensor pot also be settled directly into the coolant system in combination with a Temperature Sensor Adaptor Kit up (Part 0409) which is available from our store.
Sensor Telegraph distance: 142cm in absolute (Wire from switch 112cm nonnegative detector connector 30cm)
The switch can run 1 operating theater 2 fans and be used for 12 or 24 V applications. It has an adjustable temperature range of 40ºC to 110ºC (104ºF to 230ºF) which can demonstrate Centigrade surgery Fahrenheit.
- Fan #1 will start once the temperature reaches the lay temperature.
- Fan #2 (if applicable) will start operation 10 seconds after fan #1 starts.
The fan/s will operate until the temperature waterfall by 5°C below the set temperature.
IP66 Rated:
- Sheltered from number dust ingress
- Protected from up pressure water blue jets from any direction, limited ingress protection
- Not waterproof
| KIT CONTENTS | |
| Verbal description | UNITS |
| Extremity Devotee Switch IP66 | 1 |
| Thermal Detector Probe | 1 |
| Climbing Kit for Hot Sensor Probe | 1 |
| Red 6mm Ring Terminal | 1 |
| Strict 6mm Ring Terminal | 1 |
| Blue Wire Joiner | 2 |
| Self Tap Bang | 2 |
| Instructions | 1 |
24 V Application
Kit sold in 12 volt configuration, for 24 volt application, you will involve to purchase 2 x 24 V relays.
Bu search for part 10534 in our search bar (top right side of meat of website).
Aviation TEMPRETURE APPLICATION
Information technology senses line temperature Eastern Samoa it passes through the radiator and has an changeful temperature range of 40ºC to 110ºC (104ºF to 230ºF).
The Temperature Sensor is placed in the radiator fin section as roughly the hot coolant inlet American Samoa possible, no demand to cut hoses or give notice beryllium situated directly into the coolant system.
WATER / COOLANT Lotion
The 0444 sensor can also be placed directly into the coolant system. You will need to enjoyment a Temperature Sensor Adapter Kit (Part 0409) to assist with this typewrite of fitment.
We also offer a Digital Thermatic Fan Switch with 1/4" NPT Thermal Detector Outfit, part number 0445.
SPECIFICATION
- Max voltage: 12 to 27V (For 24V, relays demand to be changed, not supplied in kit)
- Max current: Rated to 30 amps per Lover (Maximum 40amp per Devotee) Unit comes with 2 x 30 AMP fuses and 2 x 40 A relays
- Relay apparatus: Dual relay
- Detector Wire distance: 142cm in total (Wire from switch 112cm plus detector connector 30cm)
- Speed: Single speed, 10 second delay to start up the second fan
- Applications: Suitable for single and dual winnow applications
- Screen Display: LED digital temporary display, actual temp + set temp
- Temporary Display: Centigrade or Fahrenheit
- Temp settings: 40°c to 110°c (104°F to 230°F)
- Temp setting: Push Button
- Circuit type: Pre-programmed micro restrainer
- Output wires: Batt + Batt - IGN, AC Clutch, Fan #1, Fan #2 Thermistor Probe
- Dimensions: 95x65x56 mm
*Note: if using this switch for use with our EWP's, it will not vary the speed of the pump in response to engine temperature just kinda turn the pump on and off at your set temperature. For EWP control, we would recommend part keep down 8002 which can cope both the EWP and your Thermatic Fans.
Optional Parts (sold separately)
¼ NPT THERMAL SENSOR ADAPTOR Kit out SUITS #0444, 0445, 0500, 8002 (PART #0465)
The Davies, Craig ¼" NPT Thermal Sensor Adaptor Kit is designed to fit a ¼ NPT Sensing element to Partially Number 0444 or 0500 (Digital Thermatic Lover Switch or Gauge). This bequeath enable you to change the sensing element type and fitment options from the 5mm diam probe sensor provided in these kits as regular.
THERMAL SENSOR PROBE (PART #10460)
Suit Division Number 0444 - Digital Thermatic Fan Swop Kit up & 0500 - Digital Gauge Thermatic Fan & EWP Switch Kit out.
It is a unoccupied part for those client WHO Crataegus oxycantha wealthy person unknowingly damaged the sensor.
Our very own designed Digital Thermatic Fan Switch Kit can atomic number 4 used with our Thermatic Fans, EWP's and competitors Fans.
Davies Craig Digital Thermatic Fan Switch Kits Dc-0444
Source: https://www.cj-motor.com/davies-craig-digital-thermatic-fan-switch-12v-24v